Treating Algae In Swimming Pools

It is officially summer in regards to our temperatures and green pools become more and more common every day. You can find them in vacant homes, residential swimming pools, commercial pools, or in any pool that isn’t properly maintained. We think it is extremely important to tackle this issue in a variety of different ways so we hope this blog post gives you a better understanding of why this happens and all the different factors that go into turning that green pool blue again because now more than every keeping pools sanitary is extremely important! Typically, you will see a direct correlation to green algae-filled pools with a lack of chlorine or poor filtration. Whenever you have warm water, algae loves to grow and if you don’t have the proper amount of chlorine in the water, algae will grow rapidly! The same goes for filtration, if you’re not filtering your swimming pool long enough your chances for algae growth increase. With that said, we also want to focus on other reasons why your swimming pool can be taken over by algae.

• High phosphates
• High Cyanuric Acid (CYA/stabilizer) levels
• Too low of chlorine levels
• Lack of filtration

When it comes to water chemistry, checking your phosphates regularly is important. Phosphates come from vegetation, soils, and fertilizers which is a food for algae. When phosphate levels increase in the swimming pool they must be removed because no matter how much chlorine you use, algae will still grow. Typically, with high phosphates, you will need to purchase a phosphate remover and phosphate test kit if all your other chemistry levels are within normal ranges. Other factors could be high CYA levels. CYA helps reduce chlorine loss by protecting the free chlorine in the pool from the sun’s ultraviolet rays, reducing the amount of chlorine needed to maintain proper sanitizer levels. When these levels get too high, it lessens the effectiveness of chlorine to act as a disinfectant.  Higher levels will bind with the chlorine, making it slower acting to kill bacteria and micro-organisms, and prevent algae from growing! This typically occurs because chlorine tabs have stabilizers in them. As a side note, the factor needed for Free Chlorine (FC) in relation to CYA is 0.75. This means if your CYA is 200 ppm you will need 15 ppm FC to combat algae. That is why optimal levels of CYA in your swimming pool should be between 30 – 50 ppm.

How To Treat Algae

When you’ve determined where the growth is coming from, Clark County Pool & Lawn recommends the following steps to help remove the algae:

• Identify the type of algae
• Check chlorine, pH and phosphate levels
• Check all pool equipment for leaks
• Check filtration equipment for tears in the filter grids or old sand
• Check run times for filtration
• Balance, chlorine, pH, and Total Alkalinity

If any of the above is the issue, the addition of more chlorine or increasing your filter run times should help because it is the two most common reason why it occurs. Remember If you keep your pool in good shape with balanced water chemistry, you will not only avoid the hassle of having to use various additional chemicals in the swimming pool but also dealing with the unnecessary algae bloom in your swimming pool! If you’re in need of support with weekly pool service in Las Vegas, contact us today.